Cradlepoint IBR650P-INTL User Manual download pdf (Page 114)

CRADLEPOINT COR | USER MANUAL Firmware ver. 4.2.0

7.1 Connection Manager

The router can establish an uplink via the Ethernet WAN port, WiFi as WAN, or the internal modem. If the primary WAN

connection fails the router will automatically attempt to bring up a new link on another device. This feature is called

failover. If Load Balance is enabled, multiple WAN devices may be plugged in and each may establish a link.

7.1.1 WAN Interfaces

This is a list of the available interfaces used

to access the Internet. You can enable, stop,

or start devices from this section. By using

the priority arrows (the arrows in the boxes to

the left; these show if you have more than

one available interface), you can set the

interface the router uses by default and the

order that it allows failover.

In the example shown, Ethernet is set as the primary Internet source, while the internal modem is set for failover. The

Ethernet is “Unplugged” while the modem is “Connected.”

Load Balance: If this is enabled, the router will use multiple WAN interfaces to increase the data transfer throughput by

using any connected WAN interface consecutively. Selecting Load Balance will automatically start the WAN interface and

add it to the pool of WAN interfaces to use for data transfer. Turning off Load Balance for an active WAN interface may

require the user to restart any current browsing session.

Enabled: Selected by default. Deselect to disable an interface.

Click on the small box at the top of the list to select/deselect all devices for either Load Balance or Enabled.

Click on a device in the list to reveal additional information about that device and to enable configuration options.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 209 210

No comments

Cradlepoint IBR650P-INTL User Manual Page 114