Cradlepoint IBR600 User Manual download pdf (Page 103)

CRADLEPOINT IBR600 | USER MANUAL Firmware ver. 3.3.0

7.7.1 Page 1: General

Tunnel Name: Choose a name meaningful to you.

Local Identity: This can be left blank for most users. If left blank

it will default to the IP address of the WAN connection. Currently

we only support identifiers in the form of an IP address, a user

fully qualified domain name ([email protected]) or just a

fully qualified domain name (www.mydomain.com). If the

remote side of the tunnel is configured to expect an identifier,

then both must match in order for the negotiation to succeed.

Remote Identity: This can be left blank for most users. If left

blank it will default to the IP address of the WAN connection.

Currently we only support identifiers in the form of an IP

address, a user fully qualified domain name

([email protected]) or just a fully qualified domain name

(www.mydomain.com). If no identifier is defined then no

verification of the remote peer's identification will be done.

Pre-shared Key: Create a password or key. The routers on both

sides of the tunnel must use this same key.

Mode: Tunnel or Transport. Tunnel Mode is used for

protecting traffic between different networks, when traffic must

pass through an intermediate, untrusted network. Transport

Mode is used for end-to-end communications (for example, for

communications between a client and a server).

Initiator Mode: ―Always On/Boot” or ―On Demand.‖ ―Always On/Boot‖ is used if you want the tunnel to initiate the

tunnel connection whenever the WAN becomes available. On Demand is used if you want the tunnel to initiate a

connection if and only if there is data traffic bound for the remote side of the tunnel.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 151 152

No comments

Cradlepoint IBR600 User Manual Page 103