Cradlepoint MBR1200 User Manual download pdf (Page 30)

CRADLEPOINT MBR1200 | USER MANUAL Firmware ver. 1.6.12

4.6 Wireless (WI-FI)

Use the Wireless (Wi-Fi) sub-menu configure the wireless settings for the

MBR1200. NOTE: changes made in this section may also need to be

duplicated on wireless clients that you want to connect to your wireless

network. Add Wireless Devices with WPS (WI-FI Protected Setup) Wizard

Add Wireless Device with WPS. This Wizard helps you add wireless

devices to the wireless network using the Wi-Fi Protected Setup protocol.

The wizard will prompt you to enter the PIN for the device, or ask you to

press the Configuration button on the device. If the device supports Wi-Fi

Protected Setup and has a configuration button, you can add it to the

network by pressing the Configuration button on the device and then the

WPS button on the router within 60 seconds. The WPS status LED on the

router will flash three times if the device has been successfully added to the

network.

There are several ways to add a wireless device to your network. Access to

the wireless network is controlled by a “registrar.” A registrar only allows

devices onto the wireless network if you have entered the PIN, or pressed a

Wi-Fi Protected Setup button on the device. The router acts as a registrar

for the network, although other devices may act as a registrar as well.

4.6.1 Wireless (WI-FI) Network Settings

Enable Wireless Radio. (Default: Enabled). When checked, wireless

connectivity is enabled.

Wireless Network Name. (Default: visible). The SSID name for the router.

Default: “MBR1200-xxx” where “xxx” is the last three digits of the

MBR1200‟s MAC address. The MAC address can be found on the product

label of the MBR1200.

(continued)

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 131 132

No comments

Cradlepoint MBR1200 User Manual Page 30