Cradlepoint IBR600 User Manual download pdf (Page 127)

CRADLEPOINT IBR600 | USER MANUAL Firmware ver. 3.3.0

8.4 Hotspot Services (Advanced Mode only)

Any of your networks can be enabled as a hotspot. To

enable a hotspot, you need to select a network and

set it as a hotspot in Network Settings → WiFi /

Local Networks.

NOTE: Although any network can be a hotspot, the IBR600

allows only one hotspot.

Enable Hotspot Services: Disabled by default. Click

Enabled to activate Hotspot options.

Hotspot Mode: Choose from the following dropdown

options:

 Simple: Allows ―Terms of Use‖ page and

timeout settings controlled within the router.

 RADIUS/UAM: Allows you to set up external authentication servers.

LAN Group: A single LAN Group—including both WiFi and Ethernet—can be configured as your hotspot. If you do not

already have a LAN Group configured as a hotspot, go to the WiFi / Local Networks page (you can click Configure to link

to this page) and set the Routing Mode to "Hotspot" for the LAN Group you want to use.

NOTE: Routing Mode is in the Local Network Editor under the IP Settings tab. Select a network in Network Settings → WiFi / Local Networks

and click Edit to open the Local Network Editor. The IP Settings tab will already be open: the Routing Mode dropdown menu is at the bottom.

Allow Service on 3G/4G Modems: Allows you to enable or disable hotspot access to the internet over a modem. This is

often used if the router has a main wired link and a secondary modem for failover (typically with a more expensive/limited

data plan). Select this option if you want the router to allow data traffic over the modem if the wired connection goes down.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 151 152

No comments

Cradlepoint IBR600 User Manual Page 127