Cradlepoint IBR600 User Manual download pdf (Page 66)

CRADLEPOINT IBR600| USER MANUAL Firmware ver. 3.3.0

DHCP Server:

Changing settings for the DHCP server is optional. The default selections are almost always sufficient.

DHCP Server: (Default: Enabled) When the DHCP server

is enabled, users of your network will be able to

automatically connect to the internet without any special

configuration. It is recommended that you leave this

enabled. Disabling the DHCP server is only

recommended if you have another DHCP server on your

network and it is configured properly.

Range Start and Range End: These designate the range

of values in the reserved pool of IP addresses for the

DHCP server. Values within this range will be given to any

DHCP enabled computers on your network. The default

values are almost always sufficient (default: 72 to 200, as

in 192.168.0.72 to 192.168.0.200).

Example: The IBR600 uses an IP address of 192.168.0.1 for its

primary network by default. A computer designated as a Web server

has a static IP address of 192.168.0.3. Another computer is

designated as an FTP server with a static IP address of 192.168.0.4. The starting IP address for the DHCP server needs to be 192.168.0.5 or

higher.

Lease Time: [Default: 720 minutes (12 hours)] The lease time specifies how long DHCP-enabled computers will wait

before requesting a new DHCP lease. Smaller values are better suited to busy environments.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 151 152

No comments

Cradlepoint IBR600 User Manual Page 66