Cradlepoint IBR600 User Manual download pdf (Page 94)

CRADLEPOINT IBR600 | USER MANUAL Firmware ver. 3.3.0

Keep Alive: This feature monitors the status of a tunnel. This will more accurately determine if the tunnel is alive or not.

Choose the Rate in seconds for each check (Default: 10 seconds. Range: 2 – 3600 seconds) and the number of Retry

attempts (Default: 3. Range: 1 – 255).

Page 2: Routes

Adding routes allows you to configure what types of

network traffic from the local host or hosts will be allowed

through the tunnel.

Click Add Route to configure a new route. You will need

to input the following information, defined by the remote

network:

 Network Address

 Netmask: (Default: 255.255.255.0)

You can set the tunnel to connect to a range of IP

addresses or to a single IP address. For example, you

could input 192.168.0.0 and 255.255.255.0 to connect

your tunnel to all the addresses of the remote network in

the 192.168.0.x range. Alternatively, you could select a

single address by inputting that address along with a

Netmask of 255.255.255.255.

Click Save to record each new route.

When you have finished adding routes, click Finish to save your GRE tunnel configuration.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 151 152

No comments

Cradlepoint IBR600 User Manual Page 94